Menu Actions: Difference between revisions
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
'''In schematic view:'''<br> | '''In schematic view:'''<br> | ||
[[Image:e_MenuActionsSchem.jpg|left]]<br><br>[[Measure|Measure and dimensioning]]<br>[[Line#Trim line|Trim lines]]<br>[[Load bitmap into rectangle|Insert image]] | [[Image:e_MenuActionsSchem.jpg|left]]<br><br>[[Measure|Measure and dimensioning]]<br>[[Line#Trim line|Trim lines]]<br>[[Load bitmap into rectangle|Insert image]]<br>[[Reorganisation]]<br><br>[[Concatenate a schematic and a pcb]]<br>[[Check project|Check Project]]<br>[[Symbol / Gate swap|Symbol swap or gate swap]]<br>[[Pin swap / Pad swap|Pin swap]]<br>[[Grid|Push Onto the Grid]]<br>Component names and values to the handle...<br>[[Alignment Assistant|Launch Alignment Assistant]]<br>[[Page|Insert Page]]<br>[[Page|Remove Page]]<br>[[Star shaped ground|Define starshaped signals]]<br>[[Simulation|Start Simulation]]<br>[[Block Diagram]]<br>[[Check Signals|Check all signals]]<br>[[Signal classes|Edit signal classes]]<br><br><br><br><br> | ||
Revision as of 12:43, 18 April 2016
In schematic view:
Measure and dimensioning
Trim lines
Insert image
Reorganisation
Concatenate a schematic and a pcb
Check Project
Symbol swap or gate swap
Pin swap
Push Onto the Grid
Component names and values to the handle...
Launch Alignment Assistant
Insert Page
Remove Page
Define starshaped signals
Start Simulation
Block Diagram
Check all signals
Edit signal classes
In layout view:
PCB Outline Wizard
Frontpanel
Measure and dimensioning
Trim lines
Load bitmap into rectangle
Reorganisation
Check project
Concatenate a schematic and a pcb
Realtime design rule check
Pad Swap
Generate groundplane, Thermal Pads
Teardrops
Create a slider track
Push Onto the Grid
Component Names and Values Extra
Launch Alignment Assistant
Launch Autoplacer
Compute Air Wires (Ratsnest)
Define Vias as Padstacks
Autorouter
Start EMC Check
Test points
Set PCBs as a Panel
Dimension PCB
Show lengths of signals
.