Menu Actions: Difference between revisions
No edit summary |
No edit summary |
||
| Line 25: | Line 25: | ||
[[Thermal Pads]]<br> | [[Thermal Pads]]<br> | ||
Ground plane partition<br> | Ground plane partition<br> | ||
Define starshaped signals<br> | Define starshaped signals<br><br> | ||
[[Padstack|Define Vias as Padstacks]]<br> | |||
Edit signal classes<br> | |||
[[Pin swap / Pad swap|Pad Swap]]<br> | [[Pin swap / Pad swap|Pad Swap]]<br> | ||
[[Component names and values extra]]<br> | |||
Component names and values to the handle<br> | |||
[[Teardrop]]s<br> | [[Teardrop]]s<br> | ||
[[Grid|Push Onto the Grid]]<br> | |||
[[Slider Track|Create a slider track]]<br> | [[Slider Track|Create a slider track]]<br> | ||
[[Measure|Dimension PCB]]<br> | [[Measure|Dimension PCB]]<br> | ||
[[Panel|Set PCB as a panel]]<br> | |||
Manual assembly<br><br> | |||
[[Frontpanel]]<br><br> | [[Frontpanel]]<br><br> | ||
.[[fr:Menu Actions]][[de: Schaltplanmenü Aktionen]] | .[[fr:Menu Actions]][[de: Schaltplanmenü Aktionen]] | ||
[[category:Menus]] | [[category:Menus]] | ||
Revision as of 10:17, 19 April 2016
In schematic view:
Measure and dimensioning
Trim lines
Insert image
Reorganisation
Concatenate a schematic and a pcb
Check Project
Symbol swap or gate swap
Pin swap
Push Onto the Grid
Component names and values to the handle...
Launch Alignment Assistant
Insert Page
Remove Page
Define starshaped signals
Start Simulation
Block Diagram
Check all signals
Edit signal classes
In layout view:
Measure and dimensioning
Trim lines...
Insert image...
Reorganisation
Concatenate a schematic and a pcb
Compute Air Wires (Ratsnest)
Check project
Realtime design rule check
Test points
Show lengths of signals
Start EMC Check
PCB Outline Wizard
Launch Autoplacer
Launch Alignment Assistant
Autorouter
Generate groundplane
Spacing to PCB edge...
Thermal Pads
Ground plane partition
Define starshaped signals
Define Vias as Padstacks
Edit signal classes
Pad Swap
Component names and values extra
Component names and values to the handle
Teardrops
Push Onto the Grid
Create a slider track
Dimension PCB
Set PCB as a panel
Manual assembly
Frontpanel
.