Block Diagram
See "Menu Actions"
TARGET 3001! allows to generate block diagrams very easily. Just enter the name of the block and the names of the terminals line by line. Define the schematic page where the block-schematic shall appear on. Page 7 in our case. The block in this example is created on schematic page 1.
Now you can move and drop the following block like a component:
The reference connections can be displaced within the block by M1H. Please note that key 
in the pointer toolbar is not active. Would it be so, the whole block would move. Simultaneously you will find the corresponding terminals on page 7. If you double click into the white area of the block, you will immediately be switched to the corresponding schematic page (page 7 in this case.)
Now you can move the reference symbols to the desired spot.
A M11 click onto the inner white rectangle of the block automatically switches to the desired page. The inner white rectangle has set property "EXECUTE" to value "PAGE:7" for that purpose.
The terminals of a block are just reference symbols which can be renamed or deleted. New terminals are established in menu "Actions":
