Revision as of 11:39, 17 January 2019

General

TARGET 3001! offers two internal autorouters, the Hybrid and the Contour router using different routing algorithms. You will find them in layout menu "Actions/Automatisms and assistants/...":

Furthermore TARGET 3001! offers an interface to an "External autorouter" ELECTRA which is an OEM product by cooperation with the Belgian producer www.konekt.com. You can purchase it separately.

General remarks on the use of autorouters

• Route critical pathways manually first.
• Place functional areas whichshow a certain kind of "togetherness" close to each other on your board.
• In the schematic(!) select the smallest Track width for the signals.
• Place them thoughtfully. Well placed is half routed.
• Rotate components to achieve more favorable starting positions for routing.
• Do not give up on the first attempt if you are not satisfied with the result.
• Use the two routers with different Route-Strategies (Settings).
• If the internal routers do not help, try the 14-day trial version of the Autorouter ELECTRA, which is embedded as an external Autorouter in the TARGET 3001! environment.
• Check your project optically after autorouting. Often the paths have to be optimized manually.
• Use the function "Check project" to exclude errors.
• EMC rules must be taken into account for high-frequency signals or signals with steep switching edges.

In a flash...

How to auto route...

• '...a single sided board?
  Switch e.g. copper bottom visible and set all other copper layers (e.g. copper top) to Function "Other". Fade those others out (invisible).
• ...a double sided (double-sided plated-through) board?
  fade in the copper bottom and copper top layers, set them "visible". visible. Set all other copper layer functions to "other" and invisible.
• ...a multilayer board?
  Set all copper layers you want to use for routing visible. However, copper inside layers must actually exist (e.g. assign the function "copper inside" to layers 10 and 13). TARGET 3001! has preset layer 16 (copper top, component side) and layer 2 (copper bottom, solder side). Levels 10 and 13 are already named "copper inside", but their function is set to "other". This means that the Autorouter does not yet recognize these two layers as usable copper inner layers. The handling of inner copper layers are only possible from TARGET edition economy onwards.
• '...a board without schematic?
  Place the packages inside the outline of the board and connect the pads with air lines [L]. If different signals are to have different properties (track width, aura...), they are assigned to signal classes that represent these properties.

Further information

Contour Autorouter
Hybrid Autorouter
External Autorouter Video: Watch Electra route (mute)...
Dislike routing result
Router dialogues