Documentation

Create and save a milling pattern

This article currently is under construction.


Construct your own milling pattern for use in front panel design in principle like a component package:



An example: You want to create a trapezoidal excavation with two drill holes on the right and left.

Trapez.jpg
Image: base side=32mm, opposite side=20mm, height h=23mm, hole diameter=3,1mm




First set the grid to 0.1mm, a tenth of a millimeter. Select the open rectangle from the drawing functions (pencil icon). Hover on the color field of the plane 29, Front panel (contours) and click with the right mouse button. This layer is now activated for drawing. Roughly draw a rectangle around the coordinate origin. Double-click on one of its lines and define width and height 32 x 23 mm. At the same time, assign the coordinate origin to the center (upper part of the dialog).

Fraesbild1 e.jpg
Image: Rectangle with coordinate origin in the center



Move the mouse pointer to the upper left corner of the rectangle and press the [+] key to exactly hit the coordinates of the corner point. Press Return and then press the [g] key to "drag" the corner point inwards. Do not use the mouse for this, but rather the arrow key on the keyboard. So you stay at the same height and move on the grid only to the right. Look at the coordinates in the status bar at the bottom of the window. When you have reached -10|11.5, press Return.


Fraesbild2 d.jpg
Image: Drag corner inwards



Do the same with the right corner.

Fraesbild3 d.jpg
Image: The trapezoid might look like this now.



If necessary, round the corners by selecting a line and right-clicking on one of the black end boxes to open the context menu. Here you have the option "Round corner" and then the dialog for dimensioning the rounding follows.

Now set the two 3.1mm diameter holes to the right and left of the trapezoid. You can either use the "Draw open circles" from the drawing functions or the hole from the sidebar on the left. Any existing sidebar milling pattern can be used as required. The same applies to text, which you should place on layer 30:



Fraesbild4 e.jpg
Image: Drills placed, text prepared...



Fraesbild5 d.jpg
Image: The trapezoid with drills



Highlight the whole drawing and move the mouse to the position where you would like the handle cross to appear, say on the coordinate origin (could be placed elsewhere as well). Press keyboard key [x] to save. Confirm the following dialogs. Select Frontpanel as component type and assign a meaningful name to it. We had choses Trapez_32/20/h23. Now save it. If everything is OK, just close the appearing dialog to do eventual amendments. If you would find a bug, fix it now and save again. Close this dialog since it pops up again. The milling pattern vanishes from the drawing canvas into the component database, where it can be found by its name being component type Frontpanel.now itis ready for use...





I got a question at this point