Simulate the function Part 1
From IBF-Wiki
This article is part of an introduction tutorial called CrashCourse2
Download this article as PDF-File
The simulation in TARGET 3001! is a matter of the schematic. So we switch over to it and see our well known picture:
For the simulation of the LED's function we need a voltage source, and a load resistance. Those components will not be part of the layout thus don't have a package. Find such components in the tree view in the branch Simulation. First we import a sinus - source, then a resistor.
The resistor we pick from the branch Simulation/Analog/Source/Default and connect it accordingly:
Now we set the values for source and load, first M11 on the handle cross of the resistor:
Now we enter component value "200", this stands for 200 Ohm. Press OK. Now press M11 upon the handle cross of the sinus source:
We define it's component value by 12V. By the use of the "Simulation values" button in the same dialog we set the frequency. In the following dialog press button "Edit". Afterwards a setting of the parameters can be done:
At "FREQ" enter value 50. Now the preliminaries are done. We confirm all dialogs and the schematic might look like this:
