Hint: No (active) probe in the commands. All standard voltages and currents are stored!
Back to Simulation Assistant
The simulator will save all standard voltages and currents (through sources etc..), i.e. they can be displayed and edited after the simulation by using the post processor (oscilloscope). However it is clever to limit the number of "measurements", because normally only some measuring points are of interest, and so the computation time will be reduced. The dialog "Probe" (with description) is selectable in the commands.
Note: "currents at contacts" are not standard currents!
Tip: Please consider that the selected graphs can be specified in the probe as "Show immediately (monitoring)"! If the monitoring is not selected, then the graph will not be immediately (i.e. also not during the simulation) shown in the oscilloscope, but could be activated by the menu View\Graph calculator (in the oscilloscope).