Documentation

Push&Shove

V20
V20
NEW: Push&Shove

Push&Shove mute video

Push&Shove Button
Push&Shove Button
Activate Push&Shove
Alternative: [O] for options, see below.




When routing tracks by hand, you push your track through already laid structures, while the displaced track also cascades out its neighbours. Minimum distances are always regarded so that the space on the board can be optimally used. In general the existing structures get disturbed as little as possible. The best screen optics you will get using OpenGL.

The following example illustrates the principle:


Push&Shove
Push&Shove

Image: We would like to connect the track on the right (yellow) with the anode of the diode (pad no. 1, left), but the direct way
is blocked by already laid tracks. Now we push them aside as far as necessary to connect the track to the pad of the diode.



Push&Shove
Push&Shove

Image: As soon as you touch a foreign track, its segment becomes a phantom line and indicates what the new routing structure
will look like. The design rules, espacially the spacing constraints are kept. The minimum distance between the two tracks is
defined by the largest of the following four values: aura, sinal distance, design rule minimum distance and layer distance
(=a signal can have different minimum distances on different layers).



Push&Shove
Push&Shove

Image: The further one advances to the north, the more get the following tracks affected. In turn they give space as far as needed.



Push&Shove
Push&Shove

Image: Finally, you can get through the bottleneck without ripping up existing tracks.



Push&Shove
Push&Shove

Image: A click always places the penultimate segment first, before a second click places the rest to the cursor position.



Push&Shove
Push&Shove

Image: Since we still have activated the "Place track" mode, we can finish the process without interruption.



Push&Shove
Push&Shove

Image: The finished track. In this example, we have displaced more than necessary. If you don't like this, simply use the Undo function.


Activate Push and Shove

Push and Shove does not always have to be switched on. If you want to switch it on while routing a track, press the [O] key for options and check the box in the dialog.


Check the box in the Track Options dialog
Check the box in the Track Options dialog

Image: Activate Push&Shove: Check the box in the "Track Options" dialog





I have got a question at this point...